Reference Guide

360 | Link Layer Discovery Protocol (LLDP)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Related
Commands
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
Defaults
4 x hello
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
protocol lldp (Configuration)
Enable LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults
Disabled
Command Modes
CONFIGURATION (conf-lldp)
Command
History
protocol lldp (Interface)
Enter the LLDP protocol in the INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command from the Interface
mode.
Defaults
LLDP is not enabled on the interface.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol lldp (Configuration) Enables LLDP globally.
show lldp neighbors Displays the LLDP neighbors
integer
Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module