Reference Guide

290 | IPv4 Routing
www.dell.com | support.dell.com
• show ip management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show tcp statistics
arp
Use the address resolution protocol (ARP) to associate an IP address with a MAC address in the
switch.
Syntax
arp ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
You cannot use Class D or Class E IP addresses or zero IP address (0.0.0.0) when creating a static
ARP. Zero MAC addresses (00:00:00:00:00:00) are also invalid.
Related
Commands
arp learn-enable
Enable ARP learning via Gratuitous ARP.
Syntax
arp learn-enable
ip-address
Enter an IP address in dotted decimal format.
mac-address
Enter a MAC address in nnnn.nnnn.nnnn format.
interface
Enter the following keywords and slot/port or number information:
• For the Management interface, enter the keyword
ManagementEthernet
followed by the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
clear arp-cache Clears dynamic ARP entries from the ARP table.
show arp Displays the ARP table.