Reference Guide

144 | Bare Metal Provisioning
www.dell.com | support.dell.com
reload-type
Reload the system using the specified start-up mode.
Syntax
reload-type [normal | jump-start auto-save [enable | disable] dhcp-timeout {minutes}
config-download [enable | disable]]
Parameters
Defaults
jump-start
Command Modes
EXEC Privilege
Command
History
show reload-type
Display the reload type currently configured on the system.
Syntax
show reload-type
Command Modes
EXEC Privilege
Command
History
show boot jumpstart
Display the jumpstart status at any instant.
Syntax
show boot jumpstart
Command Modes
EXEC Privilege
normal
Enable the normal reload type. The system retrieves the FTOS image and
start-up configuration files from the flash.
jump-start
Enable the BMP reload type. The system acts as a DHCP client and
downloads the FTOS image and configuration and boot files from a
specified DHCP server.
dhcp-timeout
Set the amount of time the system waits for a DHCP server response before
reverting to normal reload type.
Range: 1-50 minutes
Default: infinity
The default time is infinity; if no time is set, the system continues to wait
unless the stop jump-start command is given.
Note: Dell Force10 recommends setting the value to 2 or higher.
config-download
Specify if the system should download a configuration file from the DHCP
server or use the start-up configuration files from the flash.
Enable: Download the configuration files from the server.
Disable: Use the local start-up configuration files.
auto-save
Configure the auto save option for the downloaded configuration file.
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module