Reference Guide

Spanning Tree Protocol (STP) | 593
Displaying STP Guard Configuration
To verify the STP guard configured on port or port-channel interfaces, use the show spanning-tree 0 guard
[interface interface]
command.
Figure 33-13 shows an example for an STP network (instance 0) in which:
• Root guard is enabled on a port that is in a Root-Inconsistent state.
• BPDU guard is enabled on a port that is shut down (Error Disabled state) after receiving a BPDU.
• Bpdu filter is disabled on the ports.
Figure 33-13. Displaying STP Guard Configuration
FTOS#show spanning-tree 0 guard
Interface
Name Instance Sts Guard type Bpdu Filter
--------- -------- --------- ---------- -----------
Tengig 0/1 0 INCON(Root) Rootguard No
Tengig 0/2 0 LIS Loopguard No
Tengig 0/3 0 EDS (Shut) Bpduguard No
FTOS#