Users Guide

32 | Installing RPMs, Line Cards, and SFMs
www.dell.com | support.dell.com
Install RPMs, Line Cards, and SFMs
The installation process is the same for RPMS, line cards, and SFMs:
Figure 7-1. Installing RPMs and Line Cards into the E600i
Step Task
1 Hold the card by the edges. Avoid touching the printed circuit board and connector pins. Extend the top and bottom
card levers before you insert the card into the slot.
2 Align the card with the slot guide for the appropriate (RPM, line card, or SFM) slot and gently slide it in until the
connectors engage with the chassis backplane.
3 Rotate the lever(s) to seat the card in the chassis.
4 Secure card in place by tightening the captive screw(s) on each card.
5 Install blank panels in all unused RPM and line card slots.