Command Line Reference Guide

Open Shortest Path First (OSPFv2 and OSPFv3) | 987
Example FTOS(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
FTOS(conf-router_ospf)#
show ip ospf
c e s
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id [vrf vrf name]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
If you delete all the network area commands for Area 0, the show ip ospf command output will not list
Area 0.
Example FTOS>show ip ospf 1
Routing Process ospf 1 with ID 11.1.2.1
Supports only single TOS (TOS0) routes
It is an autonomous system boundaryrouter
SPF schedule delay 0 secs, Hold time between two SPFs 5 secs
Number of area in this router is 1, normal 1 stub 0 nssa 0
Area BACKBONE (0.0.0.0)
Number of interface in this area is 2
SPF algorithm executed 4 times
Area ranges are
FTOS>
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
vrf name
E-Series Only: Show only the OSPF information tied to the VRF process.
Version 7.9.1.0 Introduced VRF
Version 7.9.1.0 Introduced VRF
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.8.1.0
Introduced
process-id option, in support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series