Command Line Reference Guide

980 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
maximum-paths
c e s
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, enter no maximum-paths.
Parameters
Defaults
4
Command Modes
ROUTER OSPF
Command
History
mib-binding
c e s
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
Syntax
mib-binding
To mib-binding on this OSPF process, enter no mib-binding.
Defaults
None.
Command Modes
ROUTER OSPF
Command
History
Usage
Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the
first OSPF process will be used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB
responsibility.
number
Specify the number of paths.
Range: 1 to 16.
Default: 4 paths.
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 7.8.1.0 Introduced to all platforms.