Command Line Reference Guide

98 | Control and Monitoring
www.dell.com | support.dell.com
Defaults
Refer to parameters above.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When you enter the ping command without specifying an IP/IPv6 address (Extended Ping), you are
prompted for a target IP/IPv6 address, a repeat count, a datagram size (up to 1500 bytes), a timeout in
seconds, and for Extended Commands. Refer to Appendix , for information on the ICMP message
codes that return from a ping command.
Example 1
(IPv4)
FTOS#ping 172.31.1.255
Type Ctrl-C to abort.
Sending 5, 100-byte ICMP Echos to 172.31.1.255, timeout is 2 seconds:
Reply to request 1 from 172.31.1.208 0 ms
Reply to request 1 from 172.31.1.216 0 ms
Reply to request 1 from 172.31.1.205 16 ms
:
:
Reply to request 5 from 172.31.1.209 0 ms
Reply to request 5 from 172.31.1.66 0 ms
Reply to request 5 from 172.31.1.87 0 ms
FTOS#
sweep-max-size
Enter the maximum size of datagram in sweep range.
Range: 53-15359 bytes
sweep-interval
Enter the incremental value for sweep size.
1-15308 seconds
ointerface
(IPv4 only) Enter the outgoing interface for multicast packets.
• Enter the IP address in A.B.C.D format
• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Port Channel, enter the keyword port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 255 for TeraScale and 1 to 512 for ExaScale
• E-Series only For the SONET interfaces, enter the keyword sonet followed by slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.4.1.0 IPv6 pinging available on management interface.
Version 8.3.1.0 Introduced extended ping options.
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.9.1.0 Introduced VRF
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced support for C-Series
Version 7.4.1.0 Added support for IPv6 address on E-Series