Command Line Reference Guide

Open Shortest Path First (OSPFv2 and OSPFv3) | 979
ip ospf transmit-delay
c e s
Set the estimated time elapsed to send a link state update packet on the interface.
Syntax
ip ospf transmit-delay seconds
To return to the default value, enter no ip ospf transmit-delay.
Parameters
Defaults
1 second
Command Modes
INTERFACE
Command
History
log-adjacency-changes
c e s
Generate a Syslog message for OSPF adjacency state changes. When enabled, changes are logged for
both IPv4 and IPv6 adjacencies.
Syntax
log-adjacency-changes
Defaults
Disabled.
Command Mode
ROUTER OSPF
Command
History
seconds
Enter the number of seconds as the transmission time. This value should be greater than the
transmission and propagation delays for the interface.
Range: 1 to 3600.
Default: 1 second.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
Version 8.4.1.0 Introduced for IPv6.
Version 7.8.1.0 Introduced support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series