Command Line Reference Guide

946 | Object Tracking
www.dell.com | support.dell.com
track
c e s
Enter Object Tracking command mode to modify the configuration of a tracked object.
Syntax
track object-id
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Related
Commands
Usage
Information
Use this command to enter the Object Tracking mode to edit an existing configuration of a tracked
object. For example, after you enter the track object-id command, you can modify or add a delay
timer (delay command) or a metric threshold (threshold metric command) for the UP or DOWN state
of the tracked object.
track ip route metric threshold
c e s
Configure object tracking on the threshold of an IPv4 route metric.
Syntax
track object-id ip route ip-address/prefix-len metric threshold [vrf vrf-name]
To return to the default setting, enter no track object-id.
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Related
Commands
object-id
Enter the ID number of the tracked object. Range: 1 to 65535.
Version 8.4.1.0 Introduced
show track Display information about tracked objects, including configuration, current state, and clients
which track the object.
object-id
Enter the ID number of the tracked object. Range: 1 to 65535.
ip-address/
prefix-len
Enter an IPv4 address in dotted decimal format. Valid IPv4 prefix lengths are from /0 to /32.
vrf vrf-name
(Optional) E-Series only: You can configure a VPN routing and forwarding (VRF) instance
to specify the virtual routing table to which the tracked route belongs.
Version 8.4.1.0 Introduced
show track Display information about tracked objects, including configuration, current state, and
clients which track the object.
threshold metric Configure the metric threshold used to determine the UP and/or DOWN state of a
tracked route.
track resolution ip route Configure the protocol-specific resolution value used to scale an IPv4 route metric.