Command Line Reference Guide

94 | Control and Monitoring
www.dell.com | support.dell.com
line
c e s
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Syntax
line {aux 0 | console 0 | vty number [end-number]}
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
You cannot delete a terminal connection.
Related
Commands
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal connection.
Note: This option is supported on E-Series only.
console 0 Enter the keyword console 0 to configure the console port.
The console option for the S-Series is <0-0>.
vty number Enter the keyword vty followed by a number from 0 to 9 to configure a virtual terminal
line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure.
You can configure multiple lines at one time.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
access-class Restrict incoming connections to a particular IP address in an IP access control list (ACL).
password Specify a password for users on terminal lines.
show linecard Display the line card(s) status.