Command Line Reference Guide

936 | Neighbor Discovery Protocol (NDP)
www.dell.com | support.dell.com
ipv6 nd suppress-ra
e
Suppress the IPv6 router advertisement transmissions on an interface.
Syntax
ipv6 nd suppress-ra
To enable the sending of IPv6 router advertisement transmissions on an interface, use the no ipv6 nd
suppress-ra command.
Defaults
Enabled
Command Modes
INTERFACE
ipv6 neighbor
e
Configure a static entry in the IPv6 neighbor discovery.
Syntax
ipv6 neighbor {ipv6-address} {interface interface} {hardware_address}
To remove a static IPv6 entry from the IPv6 neighbor discovery, use the no ipv6 neighbor
{ipv6-address} {interface
interface} command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION
ipv6-address
Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zero
interface interface Enter the keyword interface followed by the interface type and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
fastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
hardware_address
Enter a 48-bit hardware MAC address in nn:nn:nn:nn:nn:nn format.