Command Line Reference Guide

Control and Monitoring | 93
ip tftp source-interface
c e s
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
Defaults
The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes
CONFIGURATION
Command
History
lag-audit enable
e
Enable audit functions for the LAG (port channel) egress port table.
Syntax
lag-audit enable {interval 1-100}
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number from zero (0)
to 16383.
• For a Port Channel, enter the keyword port-channel followed by a number:
C-Series and S-Series: 1-128
E-Series: 1 to 255 for TeraScale and 1 to 512 for ExaScale
• For the SONET interfaces, enter the keyword sonet followed by slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
interval
Enter the amount of time, in seconds, indicating how often the egress port
table will be audited.
Note: The amount of time selected will be in multiples of 5 seconds, i.e., 1 = 5
seconds; 10 = 50 seconds.
Range: 1 to 100
Default: 1 (audit will occur every 5 seconds)
Version 8.3.1.0 Introduced on E-Series ExaScale