Command Line Reference Guide

Multicast | 915
37
Multicast
Overview
The platforms on which a command is supported is indicated by the character — e for the E-Series,
c for the C-Series, and s for the S-Series — that appears below each command heading.
This chapter contains the following sections:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
IPv4 Multicast Commands
The IPv4 Multicast commands are:
• clear ip mroute
• clear ip mroute snooping
• ip mroute
• ip multicast-lag-hashing
• ip multicast-routing
• ip multicast-limit
• mac-flood-list
• mtrace
• queue backplane multicast
• restrict-flooding
• show ip mroute
• show ip rpf
• show queue backplane multicast
clear ip mroute
c e s
Clear learned multicast routes on the multicast forwarding table. To clear the PIM tree information
base, use clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | *}
Parameters
Command Modes
EXEC Privilege
group-address
[
source-address]
Enter multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specific group.
* Enter * to clear all multicast routes.