Command Line Reference Guide

906 | Multiple Spanning Tree Protocol (MSTP)
www.dell.com | support.dell.com
Command
History
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range command
to map it to a non-zero instance.
name
c e s
The name you assign to the Multiple Spanning Tree region.
Syntax
name region-name
To remove the region name, enter no name
Parameters
Defaults
no default name
Command Modes
MULTIPLE SPANNING TREE
Command
History
Usage
Information
For two MSTP switches to be within the same MSTP region, the switches must share the same region
name (including matching case).
Related
Commands
protocol spanning-tree mstp
c e s
Enter the MULTIPLE SPANNING TREE mode to enable and configure the Multiple Spanning Tree
group.
Syntax
protocol spanning-tree mstp
To disable the Multiple Spanning Tree group, enter no protocol spanning-tree mstp command.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
region-name
Enter the MST region name.
Range: 32 character limit
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
Version 6.5.1.0 Introduced
msti Map the VLAN(s) to an MST instance
revision Assign revision number to the MST configuration.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.2.1.1 Introduced on E-Series