Command Line Reference Guide

Multicast Listener Discovery (MLD) | 887
ipv6 mld snooping explicit-tracking
e
Enable explicit MLD Snooping tracking on an interface.
Syntax
ipv6 mld snooping explicit-tracking
To disable, use the no ipv6 mld snooping explicit-tracking command.
Defaults
Disabled
Command Modes
INTERFACE VLAN (conf-if-vl-n)
Command
History
Usage
Information
Whether the switch is the Querier or not, if snooping is enabled, the switch tracks all MLD joins. It has
separate explicit tracking table which contains group, source, interface, VLAN and reporter details.
Related
Commands
ipv6 mld snooping mrouter
e
Configure a Layer 2 port as a multicast router port.
Syntax
ipv6 mld snooping mrouter interface {interface}
Parameters
Defaults
No default values or behavior
Command Modes
INTERFACE VLAN (conf-if-vl-n)
Command
History
Version 7.4.1.0 Introduced
show ipv6 mld snooping groups Display the IPv6 MLD Snooping group information.
interface Enter the keyword interface to indicate the next-hop interface to the multicast router.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the
slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
Version 7.4.1.0 Introduced