Command Line Reference Guide

882 | Multicast Listener Discovery (MLD)
www.dell.com | support.dell.com
ipv6 mld query-interval
e
Change the transmission frequency of the MLD host.
Syntax
ipv6 mld query-interval {seconds}
To return to the default interval, use the no ipv6 mld query-interval command.
Parameters
Defaults
125 seconds
Command Modes
INTERFACE (conf-if)
Command
History
ipv6 mld query-max-resp-time
e
Set the maximum query response time advertised in the general queries.
Syntax
ipv6 mld query-max-resp-time {seconds}
To return to the default, use the no ipv6 mld query-max-resp-time command.
Parameters
Defaults
10 seconds
Command Modes
INTERFACE (conf-if)
Command
History
ipv6 mld static-group
e
Configure an MLD static group to exclude or include mode.
Syntax
ipv6 mld static-group group-address {exclude [source-address] | include source-address}
To return to default, use the no ipv6 mld static-group group-address {exclude [source-address] |
include source-address} command.
seconds
Enter the interval in seconds.
Range: 1 - 18000
Default: 125
Version 7.4.1.0 Introduced
seconds
Enter the interval in seconds.
Range: 1 - 25
Default: 10
Version 7.4.1.0 Introduced