Command Line Reference Guide

848 | Layer 2
www.dell.com | support.dell.com
show mac-address-table
c e s
Display the MAC address table.
Syntax
show mac-address-table [dynamic | static] [address mac-address | interface interface | vlan
vlan-id] [count [vlan vlan-id] [interface interface-type [slot [/port]]]]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1 FTOS#show mac-address-table
VlanId Mac Address Type Interface State
999 00:00:00:00:00:19 Dynamic Gi 0/1 Active
999 00:00:00:00:00:29 Dynamic Gi 0/2 Active
FTOS#
dynamic (OPTIONAL) Enter the keyword dynamic to display only those MAC
addresses learned dynamically by the switch. Optionally, you can also add one
of these combinations:
address/mac-address, interface/interface, or
vlan vlan-id.
static
(OPTIONAL) Enter the keyword static to display only those MAC address
specifically configured on the switch. Optionally, you can also add one of
these combinations:
address/mac-address, interface/interface, or
vlan vlan-id.
address
mac-address (OPTIONAL) Enter the keyword address followed by a MAC address in the
nn:nn:nn:nn:nn:nn format to display information on that MAC address.
interface interface (OPTIONAL) Enter the keyword interface followed by the interface type,
slot and port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
interface interface-type (OPTIONAL) Instead of entering the keyword interface followed by the
interface type, slot and port information, as above, you can enter the interface
type, followed by just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display
the MAC address assigned to the VLAN.
Range: 1 to 4094.
count (OPTIONAL) Enter the keyword count, followed optionally, by an interface
or VLAN ID, to display total or interface-specific static addresses, dynamic
addresses, and MAC addresses in use.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series