Command Line Reference Guide

844 | Layer 2
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
show cam maccheck linecard
c
Display the results of the BCMI2 check command.
Syntax
show cam maccheck linecard slot port-set port-pipe
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1 FTOS#show cam maccheck linecard 2 port-set 0
Dumping entries. From 0 to 16383.
Progress . marks 100 memory table entries.
............................Index 5576 (0x15c8) has valid entries (H: 2b9,
E: 0)
<MAC_ADDR=0xffffffffffff,VLAN_ID=0xfff,PRI=0,CPU=0,DST_DISCARD=0,SRC_DISCARD
=0,SCP=0,TGID_LO=0,PORT_TGID=0,TGID_PORT=0,T=0,TGID_HI=0,L2MC_PTR=0,MODULE_I
D=0,REMOTE_TRUNK=0,L3=0,MAC_BLOCK_INDEX=0,STATIC_BIT=1,RPE=0,MIR-
ROR=0,VALID=1,EVEN_PARITY=0,HITDA=0,HITSA=0>
..........Index 6592 (0x19c0) has valid entries (H: 338, E: 0)
interface interface (OPTIONAL) Enter the keyword interface followed by the interface type, slot and
port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to display the
MAC address assigned to the VLAN.
Range: 1 to 4094.
pre-Version 6.2.1.1 Introduced on E-Series
linecard slot (REQUIRED) Enter the keyword linecard followed by a slot number to
select the linecard for which to gather information.
C300 range: 0 to 7; C150 range: 0 to 4
port-set port-pipe (REQUIRED) Enter the keyword port-set followed by a Port-Pipe number to
select the Port-Pipe for which to gather information.
Range: 0 or 1
Version 7.6.1.0 Introduced on C-Series