Command Line Reference Guide

84 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
Usage
Information
Users entering the EXEC Privilege mode or any other configured privilege level can access
configuration commands. To protect against unauthorized access, use the
enable password command to
configure a password for the enable command at a specific privilege level. If no privilege level is
specified, the default is privilege level 15.
Related
Commands
enable xfp-power-updates
c e s
Enable XFP power updates for SNMP.
Syntax
enable xfp-power-updates interval seconds
To disable XFP power updates, use the no enable xfp-power-updates command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The chassis MIB contain the entry chSysXfpRecvPower in the chSysPortTable table. Periodically, IFA
polls the XFP power for each of the ports, and sends the values to IFM where it is cached. The default
interval for the polling is 300 seconds (5 minutes). Use this command to enable the polling and to
configure the polling frequency.
end
c e s
Return to the EXEC Privilege mode from other command modes (for example, the
CONFIGURATION or ROUTER OSPF modes).
Syntax
end
Command Modes
CONFIGURATION, SPANNING TREE, MULTIPLE SPANNING TREE, LINE, INTERFACE,
TRACE-LIST, VRRP, ACCESS-LIST, PREFIX-LIST, AS-PATH ACL, COMMUNITY-LIST,
ROUTER OSPF, ROUTER RIP, ROUTER ISIS, ROUTER BGP
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
enable password Configure a password for the enable command and to access a privilege level.
interval seconds
Enter the keyword interval followed by the polling interval in seconds.
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series