Command Line Reference Guide

Link Aggregation Control Protocol (LACP) | 833
port-channel-protocol lacp
c e s
Enable LACP on any LAN port.
Syntax
port-channel-protocol lacp
To disable LACP on a LAN port, use the no port-channel-protocol lacp command.
Command Modes
INTERFACE
Command
History
Related
Commands
show lacp
c e s
Display the LACP matrix.
Syntax
show lacp port-channel-number [sys-id | counters]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
(port-channel-number)
FTOS#show lacp 1
Port-channel 1 admin up, oper up, mode lacp
Actor System ID: Priority 32768, Address 0001.e800.a12b
Partner System ID: Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
passive
An interface is not in an active negotiating state in this mode. LACP runs on any link
configured in the passive state. Ports in a passive state respond to negotiation requests
from other ports that are in active states. Ports in a passive state respond to LACP
packets.
off
An interface can not be part of a dynamic port channel in the off mode. LACP will not
run on a port configured in the off mode.
Version 6.2.1.1 Introduced
show lacp Display the LACP information.
show interfaces port-channel Display information on configured Port Channel groups.
port-channel-number
Enter a port-channel number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
sys-id (OPTIONAL) Enter the keyword sys-id and the value that identifies a system.
counters (OPTIONAL) Enter the keyword counters to display the LACP counters.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced