Command Line Reference Guide

832 | Link Aggregation Control Protocol (LACP)
www.dell.com | support.dell.com
lacp system-priority
c e s
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Parameters
Defaults
32768
Command Modes
CONFIGURATION
Command
History
port-channel mode
c e s
Configure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
* The LACP modes are defined in the table below.
Defaults
off
Command Modes
INTERFACE
Command
History
Usage
Information
The LACP modes are defined in the following table.
Table 31-85. LACP Modes
priority-value
Enter the system-priority value. The higher the value, the lower the priority.
Range: 1 to 65535
Default: 32768
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced on E-Series
number Enter the keyword port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
active Enter the keyword active to set the mode to the active state.*
passive Enter the keyword passive to set the mode to the passive state.*
off Enter the keyword off to set the mode to the off state.*
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced
Mode Function
active
An interface is in an active negotiating state in this mode. LACP runs on any link
configured in the active state and also automatically initiates negotiation with other
ports by initiating LACP packets.