Command Line Reference Guide

Control and Monitoring | 83
do
c e s
Allows the execution of most EXEC-level commands from all CONFIGURATION levels without
returning to the EXEC level.
Syntax
do command
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION
INTERFACE
Command
History
Usage
Information
The following commands are not supported by the do command:
•enable
• disable
•exit
• config
Example FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
enable
c e s
Enter the EXEC Privilege mode or any other privilege level configured. After entering this command,
you may need to enter a password.
Syntax
enable [level]
Parameters
Defaults
15
Command Modes
EXEC
command
Enter an EXEC-level command.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
level
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15