Command Line Reference Guide

Intermediate System to Intermediate System (IS-IS) | 825
Usage
Information
Use this command to confirm that the neighbor adjacencies are operating correctly. If you suspect that
they are not, you can verify the specified area addresses of the routers by using the show isis neighbors
command.
show isis protocol
e
Display IS-IS routing information.
Syntax
show isis protocol
Command Modes
EXEC
EXEC Privilege
Example FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
FTOS#
show isis traffic
e
This command enables you to display IS-IS traffic interface information.
Syntax
show isis traffic [interface]
Parameters
interface
(OPTIONAL) Identifies the interface type slot/port as one of the following:
• For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the
slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.