Command Line Reference Guide

772 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the
Route map used in this command. If you identify a peer by IP address, the Route map overwrites either
the inbound or outbound policies on that peer.
neighbor route-reflector-client
c e s
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor ipv6-address| peer-group-name route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration,
use the no neighbor ipv6-address | peer-group-name route-reflector-client command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of
the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you
configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format.
The
:: notation specifies successive hexadecimal fields of zeros.
peer-group-name
(OPTIONAL) Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 7.4.1.0 Introduced on E-Series TeraScale