Command Line Reference Guide

756 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Related
Commands
show ip bgp ipv6 unicast peer-group
c e s
Allows you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv6 unicast peer-group [peer-group-name [summary]]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Soft reconfiguration This line indicates that soft reconfiguration inbound is configured.
Minimum time Displays the minimum time, in seconds, between advertisements.
(List of inbound and outbound
policies)
Displays the policy commands configured and the names of the Route
map, AS-PATH ACL or Prefix list configured for the policy.
For address family: Displays IPv6 Unicast as the address family.
BGP table version Displays the which version of the primary BGP routing table the
router and the neighbor are using.
Prefixes accepted Displays the number of network prefixes accepted by the router and
the amount of memory used to process those prefixes.
Prefixes advertised Displays the number of network prefixes advertised, the number
rejected and the number withdrawn from the BGP routing table.
Connections established Displays the number of TCP connections established and dropped
between the two peers to exchange BGP information.
Last reset Displays the amount of time since the peering session was last reset.
Also states if the peer resets the peering session.
If the peering session was never reset, the word never is displayed.
Local host: Displays the peering address of the local router and the TCP port
number.
Foreign host: Displays the peering address of the neighbor and the TCP port
number.
Table 29-78. Command Example fields: show ip bgp ipv6 unicast neighbors
Lines beginning with Description
show ip bgp ipv6 unicast View the current BGP routing table.
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view peer-group-specific information
for the IPv6 address family.
summary (OPTIONAL) Enter the keyword summary to view status information of the
peers in that peer group.
The output is the same as that found in show ip bgp ipv6 unicast summary
command
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale