Command Line Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 747
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Usage
Information
When you enter redistribute ospf process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
router bgp
c e s
Enter ROUTER BGP mode to configure and enable BGP.
Syntax
router bgp as-number
To disable BGP, use the no router bgp as-number command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Command
History
show capture bgp-pdu neighbor
c e s
Display BGP packet capture information for an IPv6 address on the E-Series.
Syntax
show capture bgp-pdu neighbor ipv6-address
Parameters
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
as-number
Enter the AS number.
Range: 1 to 65535.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
ipv6-address
Enter the IPv6 address (X:X:X:X::X) of a BGP neighbor.