Command Line Reference Guide

746 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
redistribute isis
c e s
Redistribute IS-IS routes into BGP.
Syntax
redistribute isis [level-1 | level-1-2 | level-2] [metric metric-value | metric-type {external |
internal}] [route-map map-name]
To stop redistribution of IS-IS routes, use the no redistribute isis command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
redistribute ospf
c e s
Redistribute OSPFv3 routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
level-1 | level-1-2
| level-2]
(OPTIONAL) Enter the type (level) of routes to redistribute.
metric (OPTIONAL) Assign metric to an interface for use with IPv6 information
metric-type
(OPTIONAL) The external link type associated with the default route advertised into a
routing domain. You must specify one of the following:
• external
• internal (Default)
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all routes).
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
process-id
Enter the number of the OSPFv3 process.
Range: 1 to 65535
match external {1
|
2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external routes.
You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPFv3 internal
routes only.