Command Line Reference Guide

IPv6 Border Gateway Protocol (IPv6 BGP) | 717
clear ip bgp * (asterisk)
c e s
Reset all BGP sessions in the specified category on the E-Series. The soft parameter (BGP Soft
Reconfiguration) clears the policies without resetting the TCP connection.
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast soft [in | out] | soft [in | out]]
Parameters
Command Modes
EXEC Privilege
Command
History
clear ip bgp as-number
c e s
Reset BGP sessions on the E-Series. The soft parameter (BGP Soft Reconfiguration) clears the policies
without resetting the TCP connection.
Syntax
clear ip bgp as-number [flap-statistics | ipv4 {multicast {flap-statistics | soft {in | out}} | unicast
{flap-statistics | soft {in | out}} | ipv6 unicast {flap-statistics | soft {in | out}| soft [in | out]
Parameters
* Enter an asterisk ( * ) to reset all BGP sessions.
ipv4 multicast soft [in | out]
(OPTIONAL) This keyword sequence sets options within the a
specified IPv4 address family.
ipv6 unicast soft [in | out]
(OPTIONAL) This keyword sequence sets options within the a
specified IPv6 address family.
soft (OPTIONAL) Enter the keyword soft to configure and activate
policies without resetting the BGP TCP session, that is, BGP Soft
Reconfiguration.
Note: If you enter clear ip bgp ip6-address soft, both inbound
and outbound policies are reset.
in (OPTIONAL) Enter the keyword in to activate only inbound policies.
out (OPTIONAL) Enter the keyword out to activate only outbound
policies.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
as-number
Enter an autonomous system (AS) number to reset neighbors belonging to that
AS. If used without a qualifier, the keyword resets all neighbors belonging to that
AS.
Range: 1 to 65535
flap-statistics (OPTIONAL) Enter the keyword flap-statistics to clear all flap statistics
belonging to that AS or a specified address family within that AS.
ipv4 (OPTIONAL) Enter the keyword ipv4 to select options for that address family.
ipv6 (OPTIONAL) Enter the keyword ipv6 to select options for that address family.
unicast (OPTIONAL) Enter the keyword unicast to select the unicast option within the
selected address family.
multicast (OPTIONAL) Enter the keyword multicast to select the multicast option within
the selected address family.
Multicast is supported on IPv4 only