Command Line Reference Guide

716 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
capture bgp-pdu neighbor (ipv6)
c e s
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv6-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
capture bgp-pdu max-buffer-size
c e s
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes
Command Modes
EXEC
EXEC Privilege
Command
History
Related
Commands
ipv6-address
Enter the IPv6 address of the target BGP neighbor.
direction {both | rx | tx}
Enter the keyword direction and a direction— either rx for inbound, tx for
outbound, or
both.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
capture bgp-pdu max-buffer-size Enable route reflection between route reflector and clients.
show capture bgp-pdu neighbor Configure a route reflector and clients.
capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet.
100-102400000
Enter a size for the capture buffer.
Version 8.4.2.1 Introduced on C-Series and S-Series.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale
capture bgp-pdu neighbor (ipv6) Enable capture of an IPv6 BGP neighbor packet.
show capture bgp-pdu neighbor Configure a route reflector and clients.