Command Line Reference Guide

680 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
IPv6 Route Map Commands
The following commands allow you to configure route maps and their redistribution criteria.
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
•route-map
• set ipv6 next-hop
• show config
• show route-map
match ipv6 address
c e s
Configure a filter to match routes based on IPv6 addresses specified in an access list.
Syntax
match ipv6 address prefix-list-name
To delete a match, use the no match ipv6 address prefix-list-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
CAM Partition Shows the CAM profile of the CAM
Available CAM Identifies the amount of CAM space remaining for that profile
Estimated CAM per Port Estimates the amount of CAM space the listed policy will require.
Status Indicates whether or not the policy will be allowed in the CAM
Table 27-75. Output Explanations: test cam-usage
Term Explanation
prefix-list-name
Enter the name of IPv6 prefix list, up to 140 characters.
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced support on the E-Series ExaScale
Version 7.8.1.0 Introduced support on the C-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16
characters long.
Version 7.4.1.0 Introduced support on the E-Series TeraScale
match ipv6 next-hop Redistribute routes that match the next-hop IP address.
match ipv6 route-source Redistribute routes that match routes advertised by other routers.