Command Line Reference Guide

668 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
Command
History
Usage
Information
The C-Series cannot count both packets and bytes, so when you enter the count byte options, only
bytes are incremented.
permit tcp
c e s
Configure a filter to pass TCP packets that match the filter criteria.
Syntax
permit tcp {source address mask | any | host ipv6-address} [operator port [port]] {destination
address | any | host ipv6-address} [bit] [operator port [port]] [count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
•Use the no seq sequence-number command syntax if you know the filter’s sequence number or
•Use the no permit tcp {source address mask | any | host ipv6-address} {destination
address | any | host ipv6-address} command.
Parameters
Version 8.4.2.1 Introduced on the S-Series
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Introduced on the C-Series
Version 7.4.1.0 Introduced on the E-Series TeraScale
Added
monitor option
source address
Enter the IPv6 address of the network or host from which the packets were sent in the
x:x:x:x::x format followed by the prefix length in the /x format.
Range: /0 to /128
The
:: notation specifies successive hexadecimal fields of zero.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the filter.
host ipv6-address Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x
format.
The
:: notation specifies successive hexadecimal fields of zero
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two port for the port
parameter.)
port port
Enter the application layer port number. Enter two port numbers if using the range
logical operand.
Range: 0 to 65535.
The following list includes some common TCP port numbers:
23 = Telnet
20 and 21 = FTP
25 = SMTP
169 = SNMP