Command Line Reference Guide

658 | IPv6 Access Control Lists (IPv6 ACLs)
www.dell.com | support.dell.com
• resequence prefix-list ipv6
•seq
• show cam-acl
• show config
• show ipv6 accounting access-list
• show running-config acl
• test cam-usage
cam-acl
c e s
Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10}
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must save the new CAM settings to the startup-config (write-mem or copy run start) then reload
the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be
reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are 1-10, except for the ipv6acl profile which is 0-10. The ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
default
Use the default CAM profile settings, and set the CAM as follows.
L3 ACL (ipv4acl): 6
L2 ACL(l2acl): 5
IPv6 L3 ACL (ipv6acl): 0
L3 QoS (ipv4qos): 1
L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl 1-10 ipv6acl
0-10 ipv4qos 1-10 l2qos 1-10
Allocate space to support IPv6 ACLs. You must enter all of the
profiles and a range.
Enter the CAM profile name followed by the amount to be allotted.
The total space allocated must equal 13.
The
ipv6acl range must be a factor of 2.
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 8.2.1.0 Introduced on the S-Series
Version 7.8.1.0 Introduced on the C-Series