Command Line Reference Guide

IPv4 Routing | 645
show ipv6 management-route
c e
Display the IPv6 static routes configured for the management interface.
Syntax
show ipv6 management-route [all | connected | summary | static]
Parameters
Command Modes
EXEC Privilege
Command
History
Example FTOS#show ipv6 management-route
IPv6 Destination Gateway State
---------------- ------- -----
2001:34::0/64 ManagementEthernet 0/0 Connected
2001:68::0/64 2001:34::16 Active
FTOS#
show ip protocols
c e s
View information on all routing protocols enabled and active on the switch.
Syntax
show ip protocols
Command Modes
EXEC
EXEC Privilege
Command
History
Example FTOS#show ip protocols
Routing Protocol is "bgp 1"
Cluster Id is set to 20.20.20.3
Router Id is set to 20.20.20.3
Fast-external-fallover enabled
Regular expression evaluation optimization enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
Neighbor(s):
all Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch.
connected Enter the keyword connected to view only routes directly connected to the Management
interface.
summary Enter the keyword summary to view a table listing the number of active and non-active routes
and their sources.
static Enter the keyword static to view non-active routes also.
Version 8.4.1.0 Introduced
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Regular evaluation optimization enabled/disabled added to display output
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series