Command Line Reference Guide

IPv4 Routing | 643
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1 FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
Example 2
(brief)
FTOS#show ip int brief
Interface IP-Address OK? Method Status Protocol
GigabitEthernet 1/0 unassigned NO Manual administratively down down
GigabitEthernet 1/1 unassigned NO Manual administratively down down
GigabitEthernet 1/2 unassigned YES Manual up up
linecard
slot-number
(OPTIONAL) Enter the keyword linecard followed by the number of the line card slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5 on a E300
Note: This keyword is not available on the S-Series.
configuration (OPTIONAL) Enter the keyword configuration to display the physical interfaces with
non-default configurations only.
Version 8.1.1.2 Supported on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Table 26-66. show ip interface Command Example Items
Lines Description
TenGigabitEthernet 0/0... Displays the interface’s type, slot/port and physical and line protocol status.
Internet address... States whether an IP address is assigned to the interface. If one is, that address is
displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If none is
configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.
Poison Reverse... States whether poison for RIP is enabled on the interface
ICMP redirects... States if ICMP redirects are sent.
ICMP unreachables... States if ICMP unreachable messages are sent.