Command Line Reference Guide

640 | IPv4 Routing
www.dell.com | support.dell.com
Related
Commands
show ip fib stack-unit
s
View all Forwarding Information Base (FIB) entries.
Syntax
show ip fib stack-unit 0-7 [ip-address [mask] [longer-prefixes] | summary]
Parameters
Command Mode
EXEC
EXEC Privilege
Command
History
Example FTOS#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr Port VId EC
------------------ --------------------------- ----------------- ------------------- -------- ---
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00 BLK HOLE 0 0
FTOS>
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
Index Displays the internal interface number.
EC Displays the number of ECMP paths.
Table 26-64. show ip fib linecard Command Example Fields
Field Description
clear ip fib linecard Clear FIB entries on a specified line card.
0-7
Enter the S-Series stack unit ID, from 0 to 7.
ip-address mask
(OPTIONAL) Enter the IP address of the network destination to view only information
on that destination.
Enter the IP address in dotted decimal format (A.B.C.D). You must enter the mask in
slash prefix format (/X).
longer-prefixes (OPTIONAL) Enter the keyword longer-prefixes to view all routes with a common
prefix.
summary (OPTIONAL) Enter the keyword summary to view the total number of prefixes in
the FIB.
Version 7.7.1.0 Modified: Added support for up to seven stack members.
Version 7.6.1.0 Introduced on S-Series
Table 26-65. show ip fib linecard Command Example Fields
Field Description
Destination Lists the destination IP address.
Gateway
Displays either the word
Direct and an interface for a directly connected route or the remote
IP address to be used to forward the traffic.
First-Hop Displays the first hop IP address.