Command Line Reference Guide

IPv4 Routing | 631
management route
c e
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {ipv4-address | ipv6-address}/mask {forwarding-router-address |
managementethernet}
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 and IPv6 management routes. This command manages both tables.
Related
Commands
show arp
c e s
Display the ARP table.
Syntax
show arp [vrf vrf name][interface interface | ip ip-address [mask] | macaddress mac-address
[mac-address mask]] [cpu {cp | rp1 | rp2}] [static | dynamic] [summary]
Parameters
{ipv4-address | ipv6-address}/
mask
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X),
followed by the prefix-length for the IP address of the management
interface.
forwarding-router-address
Enter an IPv4 or IPv6 address of a forwarding router.
managementethernet Enter the keyword managementethernet for the Management
interface on the Primary RPM.
Version 8.4.1.0 Added support for IPv6 management routes.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
interface ManagementEthernet Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management) Set the mode of the Management interface.
speed (Management interface) Set the speed for the Management interface.
vrf name
E-Series Only: Show only the ARP cache entries tied to the VRF process.
cpu (OPTIONAL) Enter the keyword cpu with one of the following keywords to view
ARP entries on that CPU:
•
cp - view ARP entries on the control processer.
•
rp1 - view ARP entries on Routing Processor 1.
• rp2 - view ARP entries on Routing Processor 2.