Command Line Reference Guide

BOOT_USER Mode | 63
Example 1
(1st field in boot
change)
BOOT_USER # boot change primary
'.' = clear field; '-' = clear non-essential field
boot device : ftp
Example 2
(Completed boot
change)
The following example shows the completed command:
BOOT_USER # boot change primary
'.' = clear field; '-' = go to previous field
boot device : ftp
file name : tt/latestlabel
Server IP address : 10.16.1.209
username : amsterdam
password : ******
BOOT_USER #
In the runtime CLI of C-Series and E-Series, use the boot system command to change the boot image
file and location.
To view the current boot configuration, use the show bootvar command.
Related
Commands
boot messages
c e
Limit the number of messages seen during system boot-up.
Syntax
boot messages {disable | enable}
Parameters
Defaults
enable (that is, all messages are displayed during boot up)
Command Modes
BOOT_USER
boot system Set the location of FTOS image files.
boot zero Remove the primary, secondary, or default boot image configuration.
show boot selection Display the current Boot Flash image selected.
show bootvar Display boot configuration information.
disable Enter the keyword disable to display fewer messages during boot-up.
enable Enter the keyword enable to display all messages during boot-up.