Command Line Reference Guide

IPv4 Routing | 625
Command
History
Usage
Information
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
You can separately configure both IPv4 and IPv6 domain name servers.
Related
Commands
ip proxy-arp
c e s
Enable Proxy ARP on an interface.
Syntax
ip proxy-arp
To disable Proxy ARP, enter no ip proxy-arp.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Related
Commands
ip redirects
e
Enable the interface to send ICMP redirect messages.
Syntax
ip redirects
To return to default, enter no ip redirects.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
This command is available for physical interfaces and port-channel interfaces on the E-Series.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
ipv6 name-server Configure an IPv6 name server.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show ip interface Displays the interface routing status and configuration.
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 6.1.1.0 Introduced for E-Series
Note: This command is not supported on default VLAN (default vlan-id command).