Command Line Reference Guide

IPv4 Routing | 613
Related
Commands
clear tcp statistics
c e s
Clear TCP counters.
Syntax
clear tcp statistics [all | cp | rp1 | rp2]
Note: These options are supported only on the E-Series.
Parameters
Command Modes
EXEC Privilege
Command
History
debug arp
c e s
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, enter no debug arp.
Parameters
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip route Assign an IP route to the switch.
show ip route View the routing table.
show ip route summary View a summary of the routing table.
all Enter the keyword all to clear all TCP statistics maintained on all switch processors.
cp (OPTIONAL) Enter the cp to clear only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to clear only the statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to clear only the statistics from Route Processor 2.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet followed by the
slot/port information.
• For the Management interface, enter the keyword
managementethernet followed by
the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed
by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.