Command Line Reference Guide

Interfaces | 603
tdr-cable-test
c e s
Test the condition of copper cables on 100/1000 Base-T modules.
Syntax
tdr-cable-test interface
Parameters
Defaults
No default behavior or setting
Command Modes
EXEC
Command
History
Usage
Information
The interface must be enabled to run the test or an error message is generated:
FTOS#tdr-cable-test gigabitethernet 5/2
%Error: Interface is disabled GI 5/2
The C-Series and S-Series do not generate log messages is generated when the link flaps down/up
during TDR tests. The E-series, does produce these log messages.
Related
Commands
show tdr
c e s
Display the TDR test results.
Syntax
show tdr interface
Parameters
Defaults
No default behavior or settings
Command Modes
EXEC
Command
History
interface Enter the keyword GigabitEthernet followed by the slot/port information for the 100/1000
Ethernet interface.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
show tdr Display the results of the TDR test.
interface Enter the keyword GigabitEthernet followed by the slot/port information for the
100/1000 Ethernet interface.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Support added for S-Series
Version 7.6.1.0 Support added for C-Series
Version 6.1.1.0 Introduced