Command Line Reference Guide

600 | Interfaces
www.dell.com | support.dell.com
Example 2
(brief)
FTOS#sh int por 1 br
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/0 (Up) *
Gi 3/1 (Down)
Gi 3/2 (Up)
FTOS#
Related
Commands
show port-channel-flow
c e s
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface interface {source-ip
address destination-ip address} |
{protocol number | icmp | tcp | udp} | {source-port number
destination-port number} | {source-mac address destination-mac address}
Parameters
Table 25-53. show interfaces port-channel brief Command Example Fields
Field Description
LAG Lists the port channel number.
Mode Lists the mode:
• L3 - for Layer 3
• L2 - for Layer 2
Status Displays the status of the port channel.
• down - if the port channel is disabled (shutdown)
• up - if the port channel is enabled (no shutdown)
Uptime Displays the age of the port channel in hours:minutes:seconds.
Ports Lists the interfaces assigned to this port channel.
(untitled)
Displays the status of the physical interfaces (up or down).
In Layer 2 port channels, an * (asterisk) indicates which interface is the primary port of the
port channel. The primary port sends out interface PDU.
In Layer 3 port channels, the primary port is not indicated.
show lacp Display the LACP matrix.
outgoing-port-channel
number
Enter the keyword outgoing-port-channel followed by the number of the port
channel to display flow information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.