Command Line Reference Guide

598 | Interfaces
www.dell.com | support.dell.com
show config
c e s
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes
INTERFACE PORTCHANNEL
Example FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
Command
History
show interfaces port-channel
c e s
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1 FTOS#show interfaces port-channel 20
Port-channel 20 is up, line protocol is up (Failover-group 1 is down)
Hardware address is 00:01:e8:01:46:fa
Port-channel is part of failover-group 1
Internet address is 1.1.120.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 2000 Mbit
Members in this channel: Gi 0/5 Gi 0/18
ARP type: ARPA, ARP timeout 04:00:00
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
channel-number For a Port Channel interface, enter the keyword port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number,
the state of the port channel, and the number of interfaces in the port channel.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced for S-Series; Modified to display LAG failover group status
Version 7.5.1.0 Introduced for C-Series
E-Series legacy command