Command Line Reference Guide

588 | Interfaces
www.dell.com | support.dell.com
Related
Commands
show range
c e s
Display all interfaces configured using the interface range command.
Syntax
show range
Command Mode
INTERFACE RANGE (config-if-range)
Command
History
Tx Power Low Alarm Flag This can be either true or false, depending on the Current Tx power
value displayed above.
Rx Power Low Alarm Flag This can be either true or false, depending on the Current Rx power
value displayed above.
Temperature High Warning Flag This can be either true or false, depending on the Current Temperature
value displayed above.
Voltage High Warning Flag This can be either true or false, depending on the Current voltage value
displayed above.
Tx Bias High Warning Flag This can be either true or false, depending on the Tx bias current value
displayed above.
Tx Power High Warning Flag This can be either true or false, depending on the Current Tx power
value displayed above.
Rx Power High Warning Flag This can be either true or false, depending on the Current Tx power
value displayed above.
Temperature Low Warning Flag This can be either true or false, depending on the Current Temperature
value displayed above.
Voltage Low Warning Flag This can be either true or false, depending on the Current voltage value
displayed above.
Tx Bias Low Warning Flag This can be either true or false, depending on the present Tx bias current
value displayed above.
Tx Power Low Warning Flag This can be either true or false, depending on the Current Tx power
value displayed above.
Rx Power Low Warning Flag This can be either true or false, depending on the Current Rx power
value displayed above.
Table 25-50. Diagnostic Data in show interfaces transceiver (Continued)
Line Description
interface Configure a physical interface on the switch.
show ip interface Displays Layer 3 information about the interfaces.
show interfaces Display information on a specific physical interface or virtual interface.
show inventory (C-Series and
E-Series)
Display the chassis type, components (including media), FTOS version including
hardware identification numbers and configured protocols.
show inventory (S-Series) Display the S-Series switch type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale
Version 8.1.1.0 Introduced on E-Series ExaScale