Command Line Reference Guide

Interfaces | 573
Time since last interface status change: 1w0d5h
FTOS#
Example 4
(10G SFP+ ,
C-Series)
FTOS#show interfaces tengigabitethernet 0/44
TenGigabitEthernet 0/44 is down, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:32:44:26
Current address is 00:01:e8:32:44:26
Pluggable media present, SFP+ type is 10GBASE-CU5M
Medium is MultiRate
Interface index is 45417732
FTOS#
Example 5
(Management
Ethernet)
FTOS#show interfaces managementethernet 0/0
ManagementEthernet 0/0 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:0b:a9:4c
Current address is 00:01:e8:0b:a9:4c
Pluggable media not present
Interface index is 503595208
Internet address is 10.11.201.5/16
Link local IPv6 address: fe80::201:e8ff:fe0b:a94c/64
Global IPv6 address: 2222::5/64
Virtual-IP is not set
Virtual-IP IPv6 address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10 Mbit, Mode half duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of “show interface” counters 04:01:08
Queueing strategy: fifo
Input 943 packets, 78347 bytes, 190 multicast
Received 0 errors, 0 discarded
Output 459 packets, 102388 bytes, 15 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:03:09
Usage
Information
On the C-Series and S-Series, the interface counter “over 1023-byte pkts” does not increment for
packets in the range 9216 > x < 1023.
The Management port is enabled by default (no shutdown). If necessary, use the ip address command
to assign an IP address to the Management port. If two RPMs are installed in your system, use the show
redundancy command to display which RPM is the Primary RPM.
Related
Commands
show interfaces configured Display any interface with a non-default configuration.
show interfaces linecard Display information on all interfaces on a specific line card.
show interfaces phy
Display auto-negotiation and link partner information
show interfaces rate Display information of either rate limiting or rate policing on the interface.
show interfaces switchport Display Layer 2 information about the interfaces.
show inventory (C-Series and
E-Series)
Display the chassis type, components (including media), FTOS version
including hardware identification numbers and configured protocols.
show inventory (S-Series) Display the S-Series switch type, components (including media), FTOS
version including hardware identification numbers and configured protocols.
show ip interface Display Layer 3 information about the interfaces.