Command Line Reference Guide

572 | Interfaces
www.dell.com | support.dell.com
Example 3
(1G SFP
Interface)
FTOS#show interfaces gigabitethernet 2/0
GigabitEthernet 2/0 is up, line protocol is down
Hardware is Force10Eth, address is 00:01:e8:41:77:95
Current address is 00:01:e8:41:77:95
Pluggable media present, SFP type is 1000BASE-SX
Wavelength is 850nm
Interface index is 100974648
Port will not be disabled on partial SFM failure
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit
Flowcontrol rx on tx on
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of “show interface” counters 1w0d5h
Queueing strategy: fifo
Input Statistics:
0 packets, 0 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes, 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output Statistics: Displays output statistics sent out the interface including:
• Number of packets, bytes and underruns out of the interface
• Packet size and the number of those packets outbound to the interface
• Number of Multicast, Broadcast and Unicast packets:
Multicasts = number of MAC multicast packets
Broadcasts = number of MAC broadcast packets
Unicasts = number of MAC unicast packets
• Number of VLANs, throttles, discards, and collisions:
Vlans = number of VLAN tagged packets
throttles = packets containing PAUSE frames
discarded = number of packets discarded without any processing
collisions = number of packet collisions
wred=count both packets discarded in the MAC and in the
hardware-based queues
Rate information... Estimate of the input and output traffic rate over a designated interval (30 to
299 seconds)
Traffic rate is displayed in bits, packets per second, and percent of line rate.
Time since... Elapsed time since the last interface status change (hh:mm:ss format).
Table 25-46. Fields in show interfaces Command Example (TeraScale)
Line Description