Command Line Reference Guide

558 | Interfaces
www.dell.com | support.dell.com
interface vlan
c e s
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
Defaults
Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes
CONFIGURATION
Command
History
Example FTOS(conf)#int vlan 3
FTOS(conf-if-vl-3)#
Usage
Information
For more information on VLANs and the commands to configure them, refer to Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. Refer to Chapter 10, Access Control Lists (ACL).
Related
Commands
keepalive
c e s
On SONET interfaces, send keepalive packets periodically to keep an interface alive when it is not
transmitting data.
Syntax
keepalive [seconds]
To stop sending SONET keepalive packets, enter no keepalive.
vlan-id
Enter a number as the VLAN Identifier.
Range: 1 to 4094.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.0 Introduced for E-Series
interface Configure a physical interface.
interface loopback Configure a loopback interface.
interface null Configure a null interface.
interface port-channel Configure a port channel group.
show vlan Display the current VLAN configuration on the switch.
shutdown Disable/Enable the VLAN.
tagged Add a Layer 2 interface to a VLAN as a tagged interface.
untagged Add a Layer 2 interface to a VLAN as an untagged interface.