Command Line Reference Guide

Interfaces | 553
Related
Commands
interface ManagementEthernet
c e
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface ManagementEthernet slot/port
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example FTOS(conf)#interface managementethernet 0/0
FTOS(conf-if-ma-0/0)#
Usage
Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). Use the ip address command to assign an
IP address to the Management port.
If two RPMs are installed in your system, use the show redundancy command to display which RPM is
the Primary RPM.
Related
Commands
interface null
c e s
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
interface Configure a physical interface.
interface null Configure a Null interface.
interface port-channel Configure a port channel.
interface vlan Configure a VLAN.
slot/port Enter the keyword ManagementEthernet followed by slot number (0-1) and port
number zero (0).
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced for C-Series
Version 6.4.1.0 Introduced for E-Series
management route Configure a static route that points to the Management interface or a
forwarding router.
duplex (Management) Clear FIB entries on a specified line card.
speed (Management interface) Clear FIB entries on a specified line card.
number
Enter zero (0) as the Null interface number.