Command Line Reference Guide

Interfaces | 551
The table below displays how FTOS negotiates the flow control values between two Dell Force10
chassis connected back-to-back using 1G copper ports.
Related
Commands
interface
c e s
Configure a physical interface on the switch.
Syntax
interface interface
Parameters
Defaults
Not configured.
Table 25-41. Negotiated Flow Control Values
Configured Negotiated
LocRxConf LocTxConf RemoteRxConf RemoteTxConf LocNegRx LocNegTx RemNegRx RemNegTx
off off off
off
on
on
off
on
off
on
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off
off on off
off
on
on
off
on
off
on
off
off
off
off
off
off
on
off
off
off
on
off
off
off
off
off
on off off
off
on
on
off
on
off
on
off
on
on
on
off
off
on
on
off
off
on
on
off
on
on
on
on on off
off
on
on
off
on
off
on
off
off
on
on
off
off
on
on
off
off
on
on
off
off
on
on
show running-config Display the flow configuration parameters (non-default values only).
show interfaces Display the negotiated flow control parameters.
interface
Enter one of the following keywords and slot/port or number information:
• For 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For SONET interfaces, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.