Command Line Reference Guide

548 | Interfaces
www.dell.com | support.dell.com
Usage
Information
This command applies only to the Management interface on the RPMs.
Related
Commands
duplex (10/100 Interfaces)
c e s
Configure duplex mode on any physical interfaces where the speed is set to 10/100.
Syntax
duplex {half | full}
To return to the default setting, enter no duplex.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
This command applies to any physical interface with speed set to 10/100.
Related
Commands
interface ManagementEthernet
Configure the Management port on the system (either the Primary or
Standby RPM).
duplex (Management)
Set the mode of the Management interface.
management route Configure a static route that points to the Management interface or a
forwarding router.
speed (Management interface)
Set the speed on the Management interface.
half Enter the keyword half to set the physical interface to transmit only in one direction.
full Enter the keyword full to set the physical interface to transmit in both directions.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.4.1.0 Introduced
Note: Starting with FTOS 7.8.1.0, when a copper SFP2 module with catalog number GP-SFP2-1T is used
in the S25P model of the S-Series, its speed can be manually set with the speed command. When the
speed is set to 10 or 100 Mbps, the duplex command can also be executed.
speed (for 10/100/1000 interfaces) Set the speed on the Base-T Ethernet interface.
negotiation auto Enable or disable auto-negotiation on an interface.